Jk's97DSM
Supporting VIP
- 523
- 225
- Apr 27, 2006
-
Norfolk,
Virginia
I just wanted to know if there was any usefulness with the wires to the ecu and what to cut out of the harness. I understand the edge temp can be used for a sensor which is probably going to be fuel pressure but is there anything else I’m missing?
Out:
1. PS Pressure switch
2. Power wire off of the boost control solenoid harness that went to the MAF
3.Green/white, green/yellow connector near firewall
4.Green/white, green/blue to the MAF
5.Cruise Control
6.AC comp. Black/white
7.Evap
8. Entire abs harness
Out:
1. PS Pressure switch
2. Power wire off of the boost control solenoid harness that went to the MAF
3.Green/white, green/yellow connector near firewall
4.Green/white, green/blue to the MAF
5.Cruise Control
6.AC comp. Black/white
7.Evap
8. Entire abs harness
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.