Carbonetics and Special Carbon Fiber, both are build to order so don't expect to get one within 3-6 months if you're lucky. They also don't provide the glass, trim or hinges.
I have a 1997 Mitsubishi eclipse RS. I need the complete hatchback with window and hinges. I heard there was a composite website that you could order one off of, but I don’t remember whereCan anybody tell me?
I'm using wire gauge drill bits as gauge pins to measure the gap. The .152 bit won't fit. The next one that does is .128.That's what I'm thinking. The pin slides in and out easily even though the measurement of the gap is a little tight. While...
How are you measuring the gap after waiting 15 minutes?If you can install/remove the grenade pin after 15 minutes, you are good. At least that is what I’ve done the past 20 years and all my timing belts have been fine.
I know questions about timing belt replacement have been beat to death on this forum, but the installation I'm working on is bugging me and I've not found an answer.This is on a 6 bolt motor with new OEM tensioner, new tensioner pulley...
Hijacking this thread, anyone got a comparison of the OEM clutch master vs non-oem clutch master? Is there a quick and easy way to tell by looking at it externally?
7 bolt rear main seal gasket is originally RTV, there is no paper gasket from factory. That's only for 6 bolt.Edit : my bad, Brian has already mentioned it above.
So, to give a conclusion (correct me if i'm wrong):Any composite HG is fine for a low HP, N/T applicationFelpro kit is fineRtv the oil pan, no gasketRtv the Rear Main Seal Housing/Holder.