Yo man! Built not bought bro! I know this is an old post. But I figured i would respond anyways. I am in Seattle. Lookin for other dsm fans. I have a 98 gs spyder
With some respectful upgrades.
No, I didnt try the gsc ones. But i know that lifters are definatly one of the parts you dont want to go "budget" on With our cars for sure.
Check them for loose pinch rings, defective oil holes and consistent spring pressure throughout the set. (Ive encountered all of these defects...
Ok guys i need some advice please.
Im on my third set of lifters For my 98 spyder 4g64 gs auto. Put in new ones about 400 miles ago and the "Tick" is already back..aargh! So i got what they said were "high performance" ones. (All sets are 3rd gen)
The newest set are from melling and under close...
Pry bar and a large flathead screwdriver to change out lifters? I am interested in this procedure as im changing out my lifters again. Put in a cheap e-bay set of 3g's. Tick is back after 500 miles uugh! So i got some "top line" ones on the way and any tips to make the job easier. Would be most...
Thanks for the tips gentlemen. Took it to a shop for some paid (expert) advice they went through the car and said it was because of old tires. I put 800 bucks worth of new tires on there recommendation. Still bad especially at freeway speeds. Sounds like a jet landing when I exit. Tires did help...
Hello my fellow DSMrs. I've got an issue I couldn't find in the forums. My 98 spyder gs with a 2.4 4g64 and auto trans has a grinding problem. It does it whenever the car is in motion. Increasing with speed. Even in neutral. I.e. coasting down a hill. I checked the wheel bearings,there fine. I'm...
Ok ok my rookie mistake. The tick is back with a vengeance now. I'm just gonna buy another set of higher quality ones and soak the hell outta them. See what happens. I'll let yall know the outcome.
Yeah. Took it on the freeway after a couple laps around the block. I didn't soak them. Just bled them out. I'm thinking I may have caused some damage from that. Also there was one defective one in the new batch. So I picked what looked like the best one out of the old ones. I was hoping to get...